BSx3-one10 Power

No. 30213
End of production


<Torque type servo>
#Torque: 17.8Kg-cm  Speed: 0.10sec/60deg(@7.4V)
#Torque: 15.2Kg-cm  Speed: 0.12sec/60deg(@6.0V)

#HCS Compatible

#Dimensions: 40.5x 26 x 21cm (Low Profile)
#Weight: 48.0g
#Operating voltage: 6.0 to 7.4V (Lipo, Life, NI-MH)
#The hard alumite aluminum Gear
#Blush-less motor
#Dual ball bearings
#The hard servo gear shaft
#The aluminum heat sink middle case
#Gold plated connector
#Black cable

#Recommend categpry
1/10 EP On road, 1/10 EP Off road, 1/10 GP On road.

Made in Japan.

  • HCS Compatible.

    HCS (High speed Communcation System) is the new high speed communication system between the receiver to the servo. The HCS mode shortens communication time of the signal which is compressed. HCS compatible servos is changing mode automatically by signal from receiver. So HCS compatible servos can use with all receivers.  
    If you want to use servos by HCS, please use with HCS compatible receivers.

    BSx3 series is equipped with a Brushless motor.

    The BSx3-one10 Power provides a strong retentive power while achieving a direct feeling of operation by the use of a Brushless motor. The cornering characteristic has a linear feeling while driving at high speeds or on a surface that has high grip.

    Installed preset settings

    The following factory MODEL settings are pre-installed. 
    You can chenge setting by Servo model selector.

    Model1: Standard setting(All category)
             2:Mild setting
             3:Standard setting
             4:Standard setting
             5:Standard setting

    *Model1 has been selected in factory setting.

    Made in Japan

    The BSx2-one-10 series: all essential parts such as the case, the gear, the motor are made in Japan.
    At the domestic factory the close inspections are executed through the delivery to secure “Thorough Made in Japan” product reliability.


    Current servos have the appearance of high speed and high power from the response of 2.4GHz and the power from Li-po batteries respectively. This creates a huge demand upon the servo. The BSx is the racing servo with the durability and operability to employ this high-spec demand.


     You can change servo's setting when you use our software" ICS Servo Manager".
    Ex, parameter of stretch. More retentivity in High grip condition, less retentivity in Low grip situation,
    You can select value by grip situation for best setting servos.


    Servo x1
    Grommet x4
    Screw for Horn x1

  • Servo Model Selector

    End of production
    No. 61029

    ICS-USB Adapter HS

    No. 61028
  • Servos

    RSx3 / BSx3 Series Manual

    Servo Manager

    ICS ServoManager Software Ver2.0.1.0
    This software can setting for RSx/BRx2/RSxone10/BSx2one10/RSx-12. Also you can use setting data from our.


    BSx2/ 3 Servos Factory setting data(for ICS Servo Manager2.0)
    This is factory setting data which can use by Servo Manager2.0.


    About ICS(new version 10.2017)