Grasper-catch-1000x1075

1. Great steering feel like tires grasping to the road!

Usually a servo's important specs are "Torque" and "Speed". The "Holding Power" in the one10 Grasper and the most important development in this servo is to feel the Torque when driving a car.
“Holding Power” is the power in which the hold position is kept in the servo. When this is strong, the steering stabilizes securely.
"Grapser " meaning to grasp tightly or grasp securely has not only become the servo’s spec but also the name.

2. New designed top case made from Aluminum!

Good "Holding Power" was born with the use of an Aluminum top case.
The case is machined after anodizing, creating a sharp design and beautiful edge line of the case.
The thickness inside the case has been shaved to the extremity, guaranteeing sufficient strength and making it a lighter weight then the former aluminum case.
Also we were particular about servo lead wire. The all black wire servo lead creates a cleaner look for installation, while having the necessary ability to carry current capacity and still maintaining a soft flexible wire for optimum routing.

3. Inheriting the BSx system!

The redesign of the motor drive calculations produced a powerful linear steering feeling.
The installed factory setting is useful for driving a car, but further adjustments of the parameters can be set by utilizing the ICS functionality with a PC.

Grasper4
 
Grasper1
BSx2-one10 Grasper  No.30207                                                                           
7.4V
Torque:10.8 Kg・cm 
Speed:0.09sec/60°
6.0V
Torque:8.0 Kg・cm 
Speed:0.1sec/60°
 


●Dimension:40.5×26×21mm ●Weight:51.0g ●Battery:6.0~7.4V (Li-po/Li-fe/Ni-MH/Ni-cd) ●Aluminum Gear ●Brushless Motor ●Dual Bearings ●Hard Gear shaft ●Aluminum Upper Case ●Heat Sink middle case ●Black color cable ●Gold Plated Connector

 
The servo is powered on there may be a slight glitch, this is normal (situation).

Related product

BSx2-one10 Grasper

End of production
No. 30207